Peripheral Connectivity - Nortel CallPilot 201i Hardware Installation

22 Chapter 2 About the 201i server
Connector type
10Base-T (RJ-45)
10/100Base-T
(RJ-45)
RS-232 COM1
(male DB-9)

Peripheral connectivity

Introduction
Peripheral equipment is attached to the 201i server on the server faceplate.
Copyright © 2007, Nortel Networks
.
Purpose
This connector provides a 10 Mbit/s Ethernet connection
between the 201i server and the Meridian 1 switch or
Communication Server 1000 system. This connection
allows the exchange of call control information between
the server and the Meridian 1 switch or Communication
Server 1000 system.
For more information about the ELAN subnet, see the
CallPilot Installation and Configuration Task List.
This connector provides a network connection for
• user desktop computers, to enable use of the
unified messaging and fax messaging features
• LAN-based server administration
If you need Ethernet 100Base-T operation at 100
Mbit/s on large Meridian 1 systems (such as Option
51), you must install the NTRH3501 backplane (tip
and ring) cable. For more information, see
4 "Installing the 201i server in a large Meridian 1
system" (page
This connector provides the connection to an external
modem. The modem allows administrators and
technical support personnel to administer the 201i
server from a remote location.
Nortel CallPilot
201i Server Hardware Installation
NN44200-301 01.01 Standard
5.0 15 February 2007
ATTENTION
37).
Nortel Networks Confidential
Chapter