Nissei WSK-1011 Manual page 8

1 INSTALLING BATTERIES
Open the battery compartment by unlocking the cover by pressing its top and
bottom.
Install two identical AAA alkaline (LR03) batteries.
Make sure that the polarities correspond to the (+) and
(–) marks inside the battery compartment.
Batteries can be easily installed or removed as their (-)
ends are pushed against the spring.
You may use nickel hydride rechargeable batteries.
NOTE: For details regarding use of rechargeable
batteries, follow the directions accompanying them.
You will hear a beep as the batteries are installed.
Close the battery compartment cover.
Do not force the battery cover into position.
PRESS
AAA (LR03)
BATTERIES
-8-
2 ADJUST DATE AND TIME AND ACTIVATE THE CLOCK
Touch "SET" KEY and keep your
finger on the key until "20 11" starts
flashing.
Clock is set in the order of year,
month, day, hour and minute.
The flashing number increases with
MEMORY KEY [1] and decreases
with KEY [2]. The number will be
fast-forwarded if you keep your
finger on the key. Touching "SET"
key will fix the number and the next
article will flash. Touching
"START/STOP" key will terminate
the setting.
As the date and time are set, clock is activated. Display of the clock while the
device is turned off indicates that the clock is activated.
Battery symbol [ ] will flash when battery power is low. Measurement
can not be made while the symbol is displayed. Replace the batteries.
Both batteries need to be replaced with new ones; do not mix new and old
batteries or different batteries.
Keep your finger
on the key.
1 2
confirm increase decrease