Section 5 Operation; Configure The Instrument; Run A Test - HACH LANGE Pocket Colorimeter II User Manual

Section 5 Operation

5.1

Configure the instrument

1. Push .
2. Push to scroll through the menu options. Push
option.
Option Description
SEL Sets the measurement range or parameter. Push
between the measurement ranges or parameters.
00:00 Sets the time in 24-hour format (hh:mm). Push
time. Push
digit.
rCL Shows the last 10 measurements recorded. Push
recorded measurements (01—most recent measurement, 10—
oldest measurement). Push
To select a measurement by number, push
and then
SCA Refer to
3. Push to go back to measurement mode.
5.2

Run a test

Chemical exposure hazard. Obey laboratory safety procedures and
wear all of the personal protective equipment appropriate to the
chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.
The basic measurement steps necessary to run a test follow. Refer to
the applicable method to run a specific test.
1. Select the applicable measurement range or parameter. Refer to
Configure the instrument
2. Prepare the blank according to the method document. Make sure to
use the correct sample cell size. Rinse the sample cell and cap with
the blank before the sample cell is filled.
to change the first digit, then
. Push to go out of this option.
Standard calibration adjust
W A R N I N G
on page 13.
to go to the next
to scroll through the measurements.
to select the number
on page 17.
to select an
to toggle
to change the
to show the
13