Health And Safety; Installation Requirments; Delivery Requirements - AGA Dual Control Series Installation Manual

Hide thumbs Also See for Dual Control Series:
Table of Contents

Advertisement

Consumer Protection
As responsible manufacturers we take care to make sure that our products are designed and constructed to meet the
required safety standards when properly installed and used.
PLEASE READ THE ACCOMPANYING WARRANTY
Any alteration that is not approved by AGA could invalidate the approval of the appliance, operation of the warranty and
could also affect your statutory rights.
In the interests of safety and effective use, please read the following before using your new AGA appliance.
THIS APPLIANCE MUST ONLY BE INSTALLED BY COMPETENT ENGINEERS WHO HAVE BEEN SPECIFICALLY
FACTORY TRAINED ON THE PRODUCT AND WHO HAVE THE APPROPRIATE EQUIPMENT.
These AGA cookers are suitable for Natural gas only, and cannot be used on any other gas. IMPORTANT: See data plate
which is situated behind the plinth cover.
The installation of the cooker must be in accordance with the relevant requirements of the Gas Safety Regulations, Building
Regulations and IEE Wiring Regulations. It should be in accordance also with any relevant requirements of the Local
Authority.
In your own interest, and that of safety to comply with the law, all gas appliances should be installed by a competent person,
in accordance with the relevant regulations. Failure to install appliances correctly could lead to prosecution.
On completion, test the gas installation for tightness.
Location
The location chosen for the appliance must permit the provision of a satisfactory flue, see 'Flue System' and an adequate
air supply. The location must also provide adequate space for servicing and air circulation around the cooker.
The AGA DC3 arrives on 1 pallet
The AGA DC5 (Hotcupboard) arrives on 2 pallets.
There must be access to the kitchen to manipulate a foot print of 1005mm x 740mm. A wooden template (skate with castor
wheels) of dimensions 1005mm x 740mm could be used to check if the AGA Dual Control fully built appliance is able to fit
through the property grounds and doors into its installation position in the kitchen. It must also be considered that the height
of the appliance is 960mm off pallet and 1100mm on the pallet, so high level obstacles/restrictions must not be overlooked.
If this skate/template can be manipulated through the property grounds and doors into position, then the AGA can
be installed as intended with no re-work.

HEALTH AND SAFETY

INSTALLATION REQUIREMENTS

DELIVERY REQUIREMENTS

3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Dual Control Series and is the answer not in the manual?

This manual is also suitable for:

Dual control dc3gDual control dc5g

Table of Contents