Abus CITADEL Alarm Set Micral Fitting And Operating Instructions page 23

Wireless remote control
SOS
Configuring the remote control(s)
1. Configuring the remote control to the alarm central
Press the MOD key (3) for 3 seconds - until the caution light flashes.
The alarm central enters into study status. Pull out the insulation film
from the battery compartment. Press one of the keys on the remote
control: code is transmitted. The caution light slowly flashes 3 times
to confirm this. If you attempt to re-learn an already taught-in remote
control, a warning tone sounds.
2. Activate the alarm central
Press Activate key (13) to activate the alarm central. Caution light flas-
hes for 60 sec. (alarm delay) and one beep sounds. After 60 sec. a
double beep will sound and the alarm central enters into alarm state.
Caution light flashes approx. every 2 seconds. During the alarm delay
you could press Deactivate key (14) to exit alarm mode and alarm
central is switched off.
Instructions for use / battery replacement
1. Press Activate key (13) or Deactivate key (14) to switch the alarm
central on and
2. By pressing the emergency button (12) you can manually trigger an
alarm, e.g. in the event of a burglary attack. Attention: depending on
the selected volume control, the alam sounds with up to 110 dbA!
LED (11)
Emergency button (12)
Activate (13)
Deactivate (14)
off.
GB
+
(inserted)
23