Table of Contents
Advertisement
1-7 Printer Test and Calibration
Preparation for Test
These procedures run a complete set of performance tests. If the printer fails a test,
troubleshoot as required, then rerun all tests.
Inspect the printer for physical damage before testing or calibrating it. Inspect for:
•
Cuts or gouges in the rubber drive roller
•
Dust buildup or other obstructions of the label sensor or sensor LED
•
Adhesive buildup or scratches on the print head
•
Adhesive buildup or other obstructions in the paper path
•
Any other physical damage that might affect printer alignment
Correct any problems found before beginning the printer calibration using the
calibration software.
NOTE:
The calibration software is DOS-based and can be run directly
from the diskette or installed on your hard drive. You must run
the software from the DOS prompt. If using Windows 95, reboot
your computer in MS-DOS mode. Do not try to run the software
in a window.
Installing the software to your hard drive:
1.
At the DOS prompt, insert the calibration disk in your computer's 3-1/2 disk
drive and access the drive.
2.
At the prompt, type dir and press the Enter key.
3.
Copy the file CX200.exe to your hard drive.
4.
Type CX200.exe to view the opening screen. Refer to the following pages
to continue with the program.
16
Rev B
All manuals and user guides at all-guides.com
SATO SERVICE MANUAL
CX Series Printers
Advertisement
Table of Contents
