Table of Contents
Advertisement
1-6 Printer Setup
Loading Ribbon (Continued)
10.
Turn the take-up knob to pull the ribbon over the print head without any slack.
Check to make sure there are no ribbon wrinkles.
11.
Lower the print head and press it down firmly until it locks closed on both sides.
12.
Close the top case.
13.
Wait until the Ready Indicator glows green and press the .EED button to feed a
label or to resume printing.
14.
If the printer feeds out 7 inches of label and stops, and the indicator glows red,
recalibrate for the media installed. See calibration.
SPINDLE
NOTCHES
BOTH ENDS
ROLL SEVERAL
TURNS ON THE
TAKE-UP CORE
All manuals and user guides at all-guides.com
SECTION 1 - GENERAL INFORMATION
PRESS BACK THE
RELEASES TO UNLOCK
SATO SERVICE MANUAL
CX Series Printers
DIRECT THERMAL
UNIT SHOWN
(NO RIBBON)
UNWIND ABOUT 4"
SPINDLE
NOTCHES
BOTH ENDS
13
Rev B
Advertisement
Table of Contents
