Table of Contents
Advertisement
3-8 PCA Base Board Removal/Replacement
REFER TO THE ACCOMPANYING ILLUSTRATIONS
PCA board removal:
1.
Remove the printer chassis according to the instructions in Section 3-4.
2.
Remove the module from the main PCA board according to the instructions
in Section 3-7.
3.
Remove the two Phillips-head screws holding the main PCA board in place.
4.
Lift the PCA board gently, then unplug the feed switch connector at J13.
5.
Turn the PCA board over and unplug all other connectors.
BACK OF THE
PCA BOARD
PCA board installation:
Reverse the above steps to install the main PCA board.
44
Rev B
All manuals and user guides at all-guides.com
REMOVE (2)
SATO SERVICE MANUAL
CX Series Printers
SCREWS
UNPLUG CONNECTOR
UNPLUG ALL
CONNECTORS
AT J13
Advertisement
Table of Contents
