Selecting The Label Sensor Type - SATO CX208 User Manual

mands that try to set it to the Thermal T Transfer mode.
A CX208TT unit is calibrated at the factory for use with SATO Stan-
dard ribbon and media. Other ribbon/media combinations may or may not
index properly with these settings. If you are experiencing difficulty with la-
bel indexing and are not using SATO labels and/or ribbon, it may be neces-
sary to recalibrate the unit for your particular ribbon/media. This can be
done by selecting the Calibration buttons provided in the Label Wizard CX CX
software or the CX208 Windows Printer Driver. If you are not using ei-
ther of these, you will have to send the calibration command directly to the
printer. See the Programming Guide for instructions on using the Sensor
Calibration command.
Important!
The ribbon must be installed in the printer when calibrat-
ing in the thermal transfer mode.

Selecting the Label Sensor Type

CX208 printers can use Eye-Mark, gap, or notch label sensing. The
sensing method used by the printer must match to the media being used. If
you are using label printing software, it should provide a means to set up
these parameters. See your software documentation for details. If you are
writing your own software or controlling the printer using direct commands,
you must use printer commands to set up the print mode and sensing
method. Refer to the programming information provided in the Program.pdf
file for further information.
ote:
The Program.pdf file is in Adobe Acrobat format. To view it, you must install
Adobe Acrobat Reader which is included on the CD-ROM in the AcroRead
directory.
Selecting the Label Sensor Type
CX200 printers can use Eye-Mark, gap, or notch label sensing. The sensing
method used by the printer must match to the media being used. If you are
using label printing software, it should provide a means to set up these pa-
rameters. See your software documentation for details. If you are writing
your own software or controlling the printer using direct commands, you
must use printer commands to set up the print mode and sensing method.
Refer to the programming information provided in the Program.pdf file for
further information.
ote:
The Program.pdf file is in Adobe Acrobat format. To view it, you must install
Adobe Acrobat Reader which is included on the CD-ROM in the AcroRead
directory.