PB TEEN Locker Bookcase Assembly Instructions

Locker Bookcase

Pre-Assembly:

Please read all instructions before beginning assembly.

Two-adult assembly is recommended.

Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware.

If using power tools to aid in assembly please use with caution. Power tools can damage hardware.

Note: Do not full tighten all bolts until all parts are in place. Failure to follow these instructions may cause the bolts

to misalign during assembly.

Phillips Head Screwdriver (Not included)

a – Stud Mounting Screws – 2pcs

Note: All parts and hardware are delivered in one carton.

Assembly Instructions:

1. Adjustable Levelers have screwed into the legs of Frame. If bookcase is not level you may slowly unscrew the

leveler to attain a level position. See Figure 1.

b – Anti-tip Bracket – 1pc

- 1 -

www.pbteen.com

c – Anti-tip Strap – 1pc

Figure 1

Table of Contents

Do you have a question about the Locker Bookcase and is the answer not in the manual?

Page 1 Locker Bookcase Pre-Assembly: Please read all instructions before beginning assembly. Two-adult assembly is recommended. Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. If using power tools to aid in assembly please use with caution. Power tools can damage hardware.
Page 2 2. The handle is pre-assembled on the interior of the drawer. Use a Phillips head screwdriver to unscrew and remove the handle and washers from drawer, then re-attach the washer and handle to the drawer as shown. See Figure 2. Figure 2 3.