Electrical Connection - ABB TZIDC-200 Commissioning Instructions

Electro-pneumatic positioner
Hide thumbs Also See for TZIDC-200:
Table of Contents

Advertisement

4

Electrical connection

Warning! Risk of explosion! (TZIDC-200 only)
It is prohibited to use the integrated communication interface (LKS) in an Ex area.
Never use the integrated communication interface (LKS) on the main board with a positioner
that is being used in an explosion risk area.
1. Strip the wire by approx. 8 mm (0.32 inch).
2. To connect the signal lines, the emergency shutdown module and the proximity switches or
microswitches, insert the wire ends from the left into the respective screw terminals and
hand-tighten the screws (access from above). To connect a plug-in module, insert the wire
ends from above in the appropriate screw terminals and hand-tighten the screws (access
from the side).
Fig. 15: Electrical connection
A Basic model
B Options
1) TZIDC-200 only
Important
Keep cable shields as short as possible and connect on both sides.
CI/TZIDC-200/210/220-EN
1 Analog input / Bus connector
2 Digital input
3 Digital output
4 Digital feedback
5 Analog feedback
6 Proximity switches
7 Microswitches
8 Emergency shutdown module
TZIDC-200, TZIDC-210, TZIDC-220
Electrical connection
1)
1)
1)
1)
EN - 19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tzidc-210Tzidc-220

Table of Contents