Commissioning; Tzidc-200 - ABB TZIDC-200 Commissioning Instructions

6

Commissioning

6.1

TZIDC-200

bieten
1. Feed in pneumatic supply power
2. Feed in electrical supply power
•
3. Check mount:
•
•
4. Run Autoadjust
For linear actuators
•
•
•
For rotary actuators
•
•
•
If Autoadjust is successful, the parameters will be stored automatically and the positioner will
revert to operating mode 1.1.
If an error occurs during Autoadjust, the process will be terminated with an error message. If
this happens, press and hold down
to the operating level, mode 1.3 (manual adjustment within the sensor range). The mount is
checked and corrected if necessary. Autoadjust then runs again.
1) The zero position is determined automatically and saved during Autoadjust (counter-clockwise (CTCLOCKW) for
linear actuators and clockwise (CLOCKW) for rotary actuators).
CI/TZIDC-200/210/220-EN
Feed in setpoint current 4 ... 20 mA (terminals +11/-12)
Press and hold , plus
the sensor range) is displayed; release
Press or to move the actuator into the mechanical end position; check the end
positions; rotation angle is displayed in degrees; for high-speed mode, press
simultaneously
Recommended range:
- between -28 ... 28° for linear actuators
- between -57 ... 57° for rotary actuators
Minimum angle: 25°
1)
:
Press and hold down
Press again and hold down until the countdown ends
Release ; this starts Autoadjust
1)
:
Press and hold down
Press again and hold down until the countdown ends
Release ; this starts Autoadjust
TZIDC-200, TZIDC-210, TZIDC-220
or until operating mode 1.3 (manual adjustment within
until is displayed; release the control button
until is displayed; release the control button
or for approximately three seconds. The unit will switch
Commissioning
and
EN - 23