Main Menu - Ingeteam Ingecon Sun Lite User Manual

MONITORING
CONFIGURATION.
LANGUAGE SELECTION.
CHANGE DATE.
START / STOP.
PARTIAL DATA RESET.
CHANGE INV NUMBER
3.4 Monitoring
Select monitoring menu MONITORIZACIÓN and then click on OK to access it:
The variables displayed in this menu are organised into seven screens. Users can move from one screen to another by using the
up and down keys y
12:00

MAIN MENU

Monitoring
Configuration
Language
Change date
Listed below is a description of the variables in each particular screen.
Screen 1.
Pout: Power (W) delivered by the inverter to the Electric Grid.
Vac: Output voltage (V) of the inverter at the Electric Grid connection.
Iac: Inverter output current (A).
Fac: Current output frequency to the Electric Grid (Hz).
PhiCos: Cosine of phi. This is the cosine of the phase angle existing between the grid voltage and the current delivered by the
inverter.
If there is no phase angle (0º), the cosine of phi is 1; cos 0º = 1.
Screen 2.
Vdc: Voltage delivered by the solar panels to the inverter.
Idc: Current delivered by the solar panels to the inverter.
Screen 3.
Alarms: Inverter alarm status. The installer has all the instructions for how to act for each specific alarm. Only the alarms men-
tioned in this manual can be of use to the user.
NumInv: The number assigned to the inverter through the menu that can be accessed from the
the communications.
Cod1: The equipment operating code. It may be requested by the Ingeteam customer service.
Cod2: The equipment operating code. It may be requested by the Ingeteam customer service.
NS: The serial number.
Page 18 of 68
Displaying the values for the principal parameters and internal variables, providing details as to the equipment operating
status.
This menu offers the possibility of changing various firmware parameters in order to adapt the inverter to different
operating conditions
This menu allows the user to seelct either Spanish or English as the display language.
To change the inverter date and time.
This menu serves to manually run or stop the inverter operation.
To zero the data stored in E.Par, T.ConP and N.ConP.
This menu makes it possible to assign an identification number to the inverter within the PV array.
respectively.
12/04/10
INGECON® SUN LITE
12:00
MONITORING
Pout: 5000 W
Vac: 229 V
Isal: 21.83 A
Fac: 49.89 Hz
PhiCos: 0.998
display in order to identify
User Manual
AAY2000IKE01
12/04/10
AAY2000IKE01
Rev. _
Date: March 2011