Functions And Controls; Main Unit (Front Panel); Main Unit (Rear Panel) - Tascam CD-X1500 Owner's Manual

2. Functions and Controls

2-1. Main Unit (Front Panel)

1 POWER switch
Turns the power on and off. The tray LEDs light
when power is supplied.
When Timer start function is on, playback begins
when power is supplied.
2 Disc trays
Insert CD into these trays, label side upwards.

2-2. Main Unit (Rear Panel)

5 OUTPUT jacks (RCA)
RCA connectors providing line level output
signals, one set each for discs 1 and 2.
6 DIGITAL OUTPUT (COAXIAL, S/PDIF)
Coaxial connectors provide digital output signals.
These connectors can output the 44.1KHz digital
signals constantly even if pitch control is activated.
7 FADER START jacks (MINI jack)
CD-X1500 can be controlled using the external
Fader start command through these jacks. Connect
the mixer which supports the fader start function
with appropriate cable as well as audio signal.
(TIP: Start, GND: back cue)
3 Tray LEDs
Lights when power is supplied.
4 OPEN keys
Open and close the appropriate tray.
NOTE
... These keys cannot be used when direct
mode (Preset menu) is off and disc is
being played back.
8 ACCESSORY (MINI DIN 6P)
Connect the optional scratch controller TT-M1.
9 REMOTE (MINI DIN 8P)
Use this connector to connect the remote control
unit.
WARNING
... DO NOT use any cable with the CD-
X1500 except the cable supplied with
the unit.
... Connect the cable in the way shown on
the illustration on the rear panel of the
CD-X1500. If you connect the cable in
any other way, you may damage the CD-
X1500.
TASCAM CD-X1500 DUAL CD PLAYER
English
7