Installation And Connection Of The Optional M12 Connectors - Leuze electronic DDLS 200 Technical Description

DeviceNet / CANopen

9.1.4 Installation and connection of the optional M12 connectors

An M12 connector set is available as an accessory. It consists of an M12 plug (power), an M12 plug
(bus), and an M12 socket (bus) with ready-made cables (Part No. 500 39348). If the M12 connector set
is used, a possible termination should be carried out with the optionally available terminal connector.
Conversion to M12 connectors
1. Remove screwed cable gland 1, 2 and 3 (spanner size = 20mm)
2. Screw M12 plug (power) into the thread of the screwed cable gland 1 that you have just
removed and tighten it with spanner SW18.
3. Screw M12 socket (bus) into the thread of the screwed cable gland 2 that you have just
removed and tighten it with spanner SW18.
4. Screw M12 plug (bus) into the thread of the screwed cable gland 3 that you have just removed
and tighten it with spanner SW18.
5. Connect cables acc. to figure 9.5 and Table 9.2.
M12 plug (Power)
M12 socket (bus),
onward bus
M12 plug (bus),
incoming bus
Figure 9.5: Installation and connection of the optional M12 connectors
(1) M12 plug (Power)
Pin 1 (brown)
Pin 2 (white)
Pin 3 (blue)
Pin 4 (black)
Pin 5 (yellow/green)
Table 9.2: Connection of M12 connectors
Note!
The orientation of the M12 connectors is not defined. The use of angular M12 connectors
as counterparts is therefore discouraged.
38
(2) M12 socket (bus),
onward bus
Vin Pin 1 (transparent)
OUT Pin 2 (red)
GND Pin 3 (black)
IN Pin 4 (white)
FE Pin 5 (blue)
DDLS 200
(3) M12 plug (bus),
incoming bus
DRAIN Pin 1 (transparent)
V+ Pin 2 (red)
V- Pin 3 (black)
CAN_H Pin 4 (white)
CAN_L Pin 5 (blue)
DRAIN
V+
V-
CAN_H
CAN_L
Leuze electronic