Operation - Bartscher Aurora 22 Manual

Hide thumbs Also See for Aurora 22:
Table of Contents

Advertisement

5.2 Operation

Prior to first use
CAUTION!
Never fill hot water into the cold water tank.
Do not fill water into the hot device; wait until it has cooled down.
Prior to first use it is necessary to run 2 or 3 cycles of water through the machine
without coffee, in order to properly rinse the unit („Preparation of coffee" steps 1-8).
Due to the nature of the system a small amount of water always remains in the container
for water. It is necessary to take this into account when refilling the container.
Always fill the water container (4) with
an amount of water equal to the
capacity of the thermo jug (6) included
with the coffee machine. The amount
of coffee brewed will be the same as
the amount of water poured.
If too much water is poured into the
water container (4), excess water will
drain out through the flow hose.
The thermo jug (6) and filter basket with insert (3) should be thoroughly washed in
warm water and a mild cleaning agent, then rinsed in clean water. Dry thoroughly
after washing.
CAUTION!
When cleaning, be aware of the remo-
vable insert at the bottom of the filter
basket. After cleaning, replace the insert
in the filter basket so that it is secured to
the bottom of the filter and will not be
accidentally thrown out while disposing
of coffee grounds.
When brewing coffee without the insert, the
paper filter can block the filter basket's drip
flow opening and hinder the flow of coffee
to the thermo jug with pump system.
Flow hose
Insert
Filter basket
- 33 -

Advertisement

Table of Contents
loading

Table of Contents