Uplift Desk MON020 Manual page 3

Range single monitor arm

CAUTIONS & WARNINGS

CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may

result in damage or personal injury. Retain manual for future reference.

Step 5

Now, insert your monitor and VESA mount assembly into the

Monitor joint mount, holding it firmly as you insert it until you

feel it click into place.

The Range Gas arm tension is factory set for the heaviest

monitor weight. To adjust the tension if the monitor is too

light for the maximum setting, hold the Gas arm horizontal

and, using 6 mm Allen wrench, turn the set screw located at

the lower section of the arm toward the "-".

Keep adjusting the tension until the monitor arm holds its

position when you let it go.

Step 6

Insert the Wire clips into the underside of the Extension arm

and the Gas arm, and run your cables through them, making

sure the cables are not pulled too tight. There should be some

slack in the cables to allow the arm to move freely without be-

ing restricted.

Monitor Ergonomics

Screen Distance: Set your screen about an arm's length (ap-

proximately 18'' - 28'') from your eyes. If print is too hard to

read, it is better to make the print larger on your screen than it

is to move the screen closer to your eyes.

Monitor Height: The top of the monitor should be at or just

below eye level.

Monitor Tilt: The monitor should be

tilted slightly up so it's easier to see

the screen when the top of the mon-

itor is level with your eyes. If the joint

holding the monitor does not move,

loosen the hex bolt on the Monitor

joint slightly with the 13 mm Flat

wrench.