Uplift Desk MON054 Quick Start Manual

Moontower Quad Monitor Arm
SKU: MON054
Package Contents
Base Cover Clamp Mount
Base
Upper Clamp
Adhesive Pad Dual Arm
Adhesive Pad
• Maximum monitor weight: 17.6 lb (each monitor)
• Recommended monitor size: up to 27"
Lower Clamp
• Desktop thickness compatibility: 0.4"-3.4" thick
There are two ways to attach the Moontower Quad Monitor Arm to your desktop. If you would like to attach it along the
Wire Cover
back edge of your desktop, follow the Clamp Method instructions on this page. If you prefer to attach it through your desk-
top, follow the Bolt-Through Method instructions starting on page 2.
Lower base plate
Clamp Method
Clamp Method
© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com • upliftdesk.com
Base Vesa mount (x1)
Base Vesa mount (x1)
Cable Clip 3mm Allen wrench
L
Upper Clamp
Vesa mount (x1)
Upper arm
3mm Allen wrench 4mm Allen wrench
L M
Upper Clamp
Adhesive Pad
Upper arm Base screw (x4)
Pole
(qty 2)
Adhesive Pad
Lower arm
M4x12 bolt (x4)
Upper arm Base screw (x4)
Lower Clamp
Lower arm
Upper base plate
Lower Clamp
Lower arm
Wire Cover
N Bolt (x4)
Upper base plate
Wire Cover
Upper base plate
Lower base plate
Bar
Lower base plate
Bar Handle
Bar Handle
Bolt-Through Method
Allen Wrenches
3mm Allen wrench 4mm Allen wrench 6mm Allen wrench
L M N
(set of three: 3mm, 5mm, 6mm)
4mm Allen wrench 6mm Allen wrench
(qty 2)
M4x12 Screw (M-A)
M N
M4x12 bolt (x4) D5 Washers (x4)
Base screw (x4) M5x12 bolt (x4)
6mm Allen wrench
M5x12 Screw (M-B)
N
M4x12 bolt (x4)
M5x12 bolt (x4) D5 Washers (x4)
M5 Washer (M-C)
M5x12 bolt (x4) D5 Washers (x4)
N Bolt (x4)
O Bolt (x4)
N Bolt (x4)
O Bolt (x4)
O Bolt (x4)
Handle
Step 1
Determine your mounting method. There are two
ways to attach the Moontower Quad Monitor Arm to
your desktop:
Clamp Method: If you would like to attach the monitor
arm along the back edge of your desktop, follow the
Clamp Method instructions (Steps 2 - 3).
Bolt-Through Method: If you prefer to attach the
monitor arm through your desktop, skip Steps 2 - 3
and follow the Bolt-Through Method instructions
(Steps 4 - 7).
Step 2 (Clamp Method)
Peel the adhesive backing off of the Adhesive Pad and
attach it to the bottom of the Clamp Mount as shown.
Align the Pad with the front edge of the Clamp Mount
base first, then work to the back.
Step 3 (Clamp Method)
A. Slide the Clamp Mount onto the back of the desk-
top, then tighten the bolt of the clamp onto your
desktop using the knob.
B. If you chose the Clamp Method for mounting,
please skip the Bolt-Through Method (Steps 4-7)
and proceed with Step 8.
Parts for
Bolt-Through assembly
(qty 16)
Bolt-Through Mount
(qty 16)
Bolt-Through Plate
(qty 16)