Installation Instructions; Handling; Disposing Of The Packing; Installation Area - Equator Super Combo EZ 4400N Owner's Manual

Handling

Please handle the machine carefully and use
appropriate means while lifting and moving the
machine so that it does not get damaged. Do not
drag the machine to your floor and, or, to the
machine. Do not hold on to protruding parts when
lifting

Disposing of the packing

The shipping package has protected your
new washing machine on its way to your home.
All packaging materials are non-poliituing and
recyclable. Please contribute to a better
environment by disposing of packing material
in an environmentally conscious manner.
Keep children away from the shipping cartoon
and packing components. Danger suffocation
from plastic foil and folding cartons.
Disposing of your old appliance
Old Appliances are not worthless trash! Valuable
raw material can be recycled from old appliances.
To prevent children from locking themselves in the
appliances, disable the door locking or remove
the door.
Factory - supplied Equipment
Inside the drum there is a packet of accessory
parts supplied with your washer. Check that all
the accessory parts supplied for your model
are there. If any parts are missing contact your
dealer.
Any residual moisture inside the drum is due to
the final testing which every washing machine
undergoes before leaving the factory.
California Proposition 65
WARNING: This product contains
chemicals known to the State of California
to cause cancer and birth defects or other
reproductive harm.

Installation area

Appliance stability is very important otherwise
washing machine could "wander" during the
spin cycles.
The installation area must be solid and even.
Soft floor surfaces such as carpets or surfaces
with foam backing are not suitable.
Do not install the washing machine outdoor
or in an area exposed to freezing condition.
frozen hoses can tear / burst.
If the washing machine is located in a room
which will be exposed to temperatures below
freezing point, or if it is located in a cabin that is
being shutdown for the winter, any residual water
in the pump or water inlet hoses must be drained.
Removing the shipping rods
The shipping rods must be removed before
using the appliance for the first time and must
be retained for any future transport.
(e.g when moving)
Use Venting dry mode only after removal
of rear vent plate covering exhaust fan
as it is a fire hazard.
8