SawStop JSS-120A60 Owner's Manual page 58

|
58
®
SawStop Jobsite Saw Pro
Rotate blade until marked point is just above
2
table, but toward back of saw. Repeat
measurement with combination square. If
measurement is within 0.01" (0.025 mm), no
adjustment is needed. If not, proceed to next
step.
Loosen arbor nut and slide blade over
3
slightly.
Locate adjustment bolt, which is down and
4
left of blade, inside table insert opening. Use
4 mm hex key wrench to rotate bolt clockwise
to move blade right, and counterclockwise
to move blade left. Once adjusted, tighten
arbor nut. Return to step 2 and make further
adjustments as necessary.