Craftsman 320 Series Owner's Manual page 9

X and Y bubbles are in the centre of each vial. (Fig6)
2. If the Green rotary laser level is in vertical position, adjust the "Y" wheel. The "Y"
wheel controls the Z bubble vial. Adjust the "Y" wheel to make sure the bubble of Z
vial is in the centre of the vial.
NOTE: The Green rotary laser level can be mounted on a tripod (sold separately) or
mounted on the wall mount base by using thread holes located on level base plate or
side base plate.
Level the mounting plate on the tripod base as closely as possible before mounting
the Green rotary laser level. After mounting and securing the level to the tripod base
plate, perform steps 1 and 2 above to level the tool to its new position.
Marking a series of level points
1. Adjust the X&Y wheels to center the bubble of the vials.
2. Turn on the laser
3. Align the laser beam to your target by pressing the left arrow button or right arrow
button.
The tool can be used of marking a series of points either in the horizontal or vertical
directions.
Adjusting the laser rotating speed
1. Place the Green rotary laser level on a horizontal surface or vertical position or on
a tripod stand (sold separately).
2. Level the tool.
3. Press the power button to turn on the level.
4. Press the rotation button once for "fast" speed; twice for" medium" speed; third
time for "slow" speed; or fourth time to stop rotation.
You can choose different speeds depending on different work surroundings. Selecting
the best scan speed for your working
conditions and job requirements gives you a
highly visible level reference line.
Making a chalk line (see Fig.7)
1. Place the Green rotary laser level on a
horizontal surface or on a tripod stand (sold
separately).
2. Level the tool.
Fig.7
9