Craftsman 320 Series Owner's Manual page 15

The wall mount base can be hung from nails or screws on a wall or clamped on a
beam. By using the wall mount base, you can easily adjust the height and direction of
the laser to your reference object.
• Hang from nails or screws:
The base has three mounting holes for safety hanging. To ensure firmly hanging,
always use three screws or nails and make sure these screws or nails have been
firmly pinned up in the wall.
• Clamp on a level beam
The base can only be attached on "－" level beam, do not try to attach on a vertical
beam.
1. Turn the four lock screws (2) counterclockwise, as fig.18 shown; attach the wall
mount base to a level beam, make sure the beam is fixed in the full inner position of
the trough (1)
2. Turn the four lock screws clockwise to secure the clamp. The four rubber blocks
can protect the beam from clamping damage.
3. Adjust the balance screw (9) to make the rubber support against the wall, ensure
the platform is approximately level, as fig.19 shown.
Fig. 18 Fig. 19
• Mount the rotary laser on the wall mount base
1. Align the 5/8" screw of the platform with the screw hole of the tool in the bottom
base or side base.
2. Adjust the direction of the tool to your reference object.
3. Turn the screw clockwise to secure the tool on the base as fig.20 shown.
CAUTION! Whenever use the wall mount base to secure the green rotary laser
on the beam, BE SURE to place the tool on the base carefully, securing it with your
hands at all time, once you are sure the tool is fixed firmly on the base with the screw
and the base is fastened on the beam, you can remove your hands safely.
15