Craftsman 320 Series Owner's Manual page 13

laser line is under the lineation slot, you should move downwards to close and
match the laser line. The upward arrow tells you to move the tool upwards.
3. If the laser line is detected aligned with the lineation slot, a black line will appear
on the center of the LCD and the buzzer will sound continuously. It tells you the
position of the laser line is.
4. To accurately locate the position of the laser line, you can push the Coarse/Fine
detection button to choose a fine detection mode, as figure 12(b) and 12(c)
shown, more narrow of the two lines means more accurate of the detection.
Repeat step 2 and 3 to locate the laser line.
5. When the laser line is located, you can mark this position with pencil through
either side of the lineation slot.
Detector mounting base
Description
Fig.14
5
3
1
Using the detector mount base
Use the special detector mount base; you can easily fix the detector on a vertical pillar
for convenient use.
1. Inert the 1/4" mounting thread screw (4) into the 1/4" mounting hole at the back of
the detector, tighten the screw to fix the detector securely as Fig.15.
2. Press the two release buttons at the same time to slide the quick clamp and fix on
the vertical pillar as Fig.16.
3. Turn the tightening screw clockwise to keep the clamp securely fixed with the
pillar.
4
2
1. Tightening knob: used for fixing the
detector to vertical pillar tightly.
2. Release button: it locates on the both
sides of the quick clamp; push the
buttons to slide the quick clamp.
3. Quick clamp: slide it to quickly clamp
or unclamp
4. 1/4" Mounting thread screw: Used for
fixing detector.
5. Round vial: indicate if the base is
vertical and level.
13