Usb Board - HP ProBook 440 G7 Maintenance And Service Manual

USB board

Table 5-11 USB board and cable descriptions and part numbers
Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1. Prepare the computer for disassembly
2. Place the computer in Battery Safe mode
3. Remove the bottom cover
4. Remove the battery
Remove the USB board:
1. Disconnect the cable from the ZIF connector on the USB board (1).
2. Remove the two Phillips M2.0 × 4.0 screws (2) that secure the board to the computer.
3. Lift the rear of the board up (3), and then pull the board away from the connector and out of the
computer to remove it (4).
Reverse this procedure to install the USB board.
(Preparation for disassembly on page
(Battery Safe mode on page
(Bottom cover on page
(Battery on page 36).
33).
34).
Component replacement procedures
Spare part number
L44578-001
33).
51