Fingerprint Sensor Assembly - HP ProBook 440 G7 Maintenance And Service Manual

Fingerprint sensor assembly

Table 5-13 Fingerprint sensor assembly descriptions and part numbers
Description
Fingerprint sensor assembly
Fingerprint sensor bracket (included in Bracket Kit)
Fingerprint sensor cable (included in the Cable Kit)
Fingerprint sensor insert (included in Plastics Kit; for use in models without a fingerprint sensor)
Before removing the fingerprint sensor assembly, follow these steps:
1. Prepare the computer for disassembly
2. Place the computer in Battery Safe mode
3. Remove the following components:
a. Bottom cover
b. Battery
c. Hard drive
Remove the fingerprint sensor assembly:
1. Disconnect the cable from the ZIF connector on the fingerprint sensor (1).
2. Lift the two plastic tabs that hold the bracket in place (2).
3. Slide the bracket toward the inside of the computer, and then lift it off the fingerprint sensor board (3).
TIP: A tool may be required to release the bracket.
(Bottom cover on page
(Battery on page 36).
(Hard drive on page 44)
(Preparation for disassembly on page
(Battery Safe mode on page
34).
Spare part number
L77229-001
L77264-001
L77263-001
L77265-001
33).
33).
Component replacement procedures 53