M.2 Solid-State Drive - HP ProBook 440 G7 Maintenance And Service Manual

M.2 solid-state drive

Table 5-6 Solid-state drive descriptions and part numbers
Description
512 GB, PCIe, TLC
512 GB, PCIe, value
512 GB PCIe + 32 GB Optane memory
256 GB, PCIe, value
256 GB PCIe + 16 GB Optane memory
128 GB, SATA-3, TLC
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Place the computer in Battery Safe mode
3. Remove the bottom cover
4. Remove the battery
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the solid-state drive to the computer.
2. Remove the solid-state drive (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
(Preparation for disassembly on page
(Battery Safe mode on page
(Bottom cover on page
(Battery on page 36).
33).
34).
Component replacement procedures
Spare part number
L78063-001
L78064-001
L85514-001
L78062-001
L85343-001
L78061-001
33).
43