Connections; About Camera Power And Control; Power Source Options - Bosch MIC IP ultra 7100i Installation Manual

42 en | Connections
13

Connections

13.1

About Camera Power and Control

The camera incorporates a network video server that encodes video images and PTZ control
commands for transmission over a TCP/IP or UDP/IP network.
With its H.264 or H.265 encoding, it is ideally suited for IP communication and for remote
access to digital video recorders and multiplexers. Use existing networks to achieve quick and
easy integration with CCTV systems or local networks. Several receivers can receive video
images simultaneously from a single camera.
13.2

Power Source Options

The camera can be powered by a network compliant to High Power-over-Ethernet using a
Bosch model of High PoE Midspan (sold separately). With this configuration, only a single
cable connection (Cat5e/Cat6 Shielded Twisted Pair (STP)) is needed to view, to power, and
to control the camera.
For maximum reliability, the camera can be connected simultaneously to a High PoE Midspan
and a separate 24 VAC power source. If High PoE and 24 VAC are applied simultaneously, the
camera usually selects the High PoE Midspan and will draw minimal power from the auxiliary
input (24 VAC). If the High PoE Midspan power source fails, the camera switches power input
seamlessly to 24 VAC. After the High PoE Midspan power source is restored, the camera
switches power input again to the High PoE Midspan.
Bosch recommends 24VAC power output of 24V at 100VA, 4A with a slow blow fuse.
Camera models
Models with illuminator
Models without illuminator
* recommended: 24V at 100VA, 4A with a slow blow fuse
Bosch recommends only a midspan power source for models with an attached illuminator.
The table below identifies the power devices that can be connected simultaneously to the
camera.
60 W midspan
95 W midspan
Notice!
Connect the 24 VAC connections from the MIC camera to the heater output of the power
supply (VG4-A-PSU1 or VG4-A-PSU2).
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
!
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
2019-07-03 | 0.17 |
60 W midspan
If power is supplied from:
Installation Manual
MIC IP ultra 7100i │ MIC IP starlight 7100i
95 W midspan
X
X X
Camera can receive power simultaneously from:
24 VAC PSU: VG4-A-PSU1 or VG4-A-PSU2
24 VAC PSU*
X
X
Bosch Security Systems