Bosch MIC IP ultra 7100i Installation Manual page 40

40 en | (Optional) Canting the Camera
Figure 12.3: Cant the camera head.
6. Reinsert the screws into both yoke arms. Note the letter assigned to each screw in the
figure below.
Figure 12.4: Reinsert the screws in the yoke arms in the following sequence: ABCD.
7. Using a torque wrench (user-supplied), tighten the screws to the proper torque using the
sequence described in the table below.
8. Recheck all four screws to ensure the proper torque value.
Do not use grease on the screws.
9. Attach the yoke caps using the supplied spanner wrench.
Note: Tighten each yoke cap until it is flush with the yoke arm.
2019-07-03 | 0.17 |
B C
A
1.
A B
2.
A B
3.
C D
4.
A B
D
C D 7.5 Nm
17 Nm
A B
D 17 Nm
C
C D
17 Nm
Installation Manual
MIC IP ultra 7100i │ MIC IP starlight 7100i
5mm Hex
(T30 Torx)
(5.5 ft lb)
(12.5 ft lb)
(12.5 ft lb)
(12.5 ft lb)
Bosch Security Systems