Bosch MIC IP ultra 7100i Installation Manual page 39

MIC IP ultra 7100i │ MIC IP starlight 7100i
Notice!
Install the applicable accessories (illuminator, sunshield) before you cant the camera.
Use the correct set of tools as well as the recommended torque values given in the
instructions that follow. The use of the wrong tools or torque values may cause damage to
threads or seal caps, which may result in leaks or damage to paint, which then may lead to the
start of corrosion.
Bosch strongly recommends attaching the camera to a DCA and mounting the DCA before
canting the camera.
To cant the camera, follow these steps:
1. Remove the yoke cap (item 2 in the figure below) on one yoke arm of the camera, using the
supplied spanner wrench (item 1).
Repeat for the second arm.
Figure 12.2: Remove the yoke caps with the spanner tool.
2. Remove the two (2) screws at the bottom of one yoke arm using a wrench (user-supplied)
as described below.
Notice!
Risk of damage to the device.
Without the yoke arm screws in position, the camera head can fall and be damaged. Hold the
head of the camera as you complete the next four (4) steps.
3. Put the screws in a safe place. You will reinstall the screws at step 6.
4. Repeat steps 2 and 3 for the second yoke arm.
5. Rotate the arms and the head assembly forward.
Notice!
Risk of damage to the device.
Do not cant the camera, or let it fall, in the wrong direction. The camera should cant only in
the direction indicated in the figure directly below.
Bosch Security Systems Installation Manual
(Optional) Canting the Camera | en
2019-07-03 | 0.17 |
39