Danfoss ECtemp 850 IV Installation Instruction page 17

Installation instruction
Installation of roof system
The installation of a ECtemp 850 with 1 roof system has been selected.
It is optional if the sensors are connected to the ECtemp 850 before power on or dur-
ing the installation.
The system uses the output System A.
If sensors for System A are not connected
Press or wait...
System is being scanned to find type of connected
sensors...
Select system type: Roof
Wait until correct number of sensors for System A
is found.
Press when all sensors are found...
System A is installed...
System is being checked...
Press to configure System A (naming sensors
and changing factory settings).
Please refer to "Changing parameters and performance of systems" in "User Manual"
for description of the configurable parameters.
If for some reason you do not wish to configure the system now you can press
to skip configuration of system.
Press to end configuration.
08097083 / VIMHE202
ECtemp 850 IV
— do it now!
CONNECT SENSORS:
SYSTEM A
SYSTEM A
SCANNING...
SYSTEM TYPE:
ROOF
1 ROOF SENSOR
FOUND. ACCEPT?
SYSTEM A!
INSTALLED
CHECKING SYSTEM
<-------->
CONFIG SYSTEM:
SYSTEM A
PRESS  TO END
CONFIGURATION.
© Danfoss | 2019.07 | 17