Stand-By (Optional); Telecoil (Optional) - oticon BTE 312 Instructions For Use Manual

stand-by (optional)

Push the button for a minimum of 3 seconds to set the instrument in stand-by mode.
Use this stand-by function to silence the instrument
while in operation.
To reactivate the instrument, push the button briefly
again.
Note: Pushing either side of the button for 3 seconds
will set the instrument on stand-by.
ImPortant notIcE
Do not use the stand-by function as a "switch off" as the hearing instrument still
draws power from the battery in this mode.
Push 3 sec
20

telecoil (optional)

The telecoil is a receiver for audio signals transmitted from an inductive loop installation.
The telecoil is meant for telephone conversations and for loop systems in e.g. theatres,
churches or lecture rooms, marked with the following symbol.
OR
The telecoil is activated by selecting the telecoil program using the push-button.
When activated, a certain number of beeps corresponding to the telecoil program
will be played.
See "Programs" to see where the telecoil program is placed.
21