Volume Control And Connectline (Optional); Stand-By (Optional) - oticon Safari BTE 13 SP Instructions For Use Manual

Volume control and connectLine (optional)

Make sure to set the volume control on the instrument in the 1 to 4 range to enable use
of the Streamer for remote control of the volume, for phone calls and TV/music streaming.
Streaming cannot be initiated while the instrument volume control is set to the inactive
'click' position.
If you use the Streamer to adjust the regular hearing instrument listening volume, the
resulting volume will no longer match the indications on the volume wheel. Turning the
volume control to the inactive 'click' position and back into the 1-4 range or turning the
instrument off and back on will reset the volume to the setting indicated on the volume
wheel.
When adjusting the volume Streamer to the preferred level you will hear a double beep.
During audio streaming, adjust the volume on the Streamer. The Streamer will control
the volume of the audio input independently of the setting of the volume wheel.
18

stand-by (optional)

Push the button for a minimum of 3 seconds to set the instrument to stand-by mode.
Use this stand-by function to silence the instrument
while in operation.
To reactivate the instrument, push the button briefly again.
Note: Pushing the button on either instrument for 3 seconds
will set both instruments on stand-by.
Important notIce
Do not use the stand-by function as a "switch off" as the hearing instrument still
draws power from the battery in this mode.
Push 3 sec
19