Audible And Visual Indicators - oticon BTE 312 Instructions For Use Manual

audible and visual indicators

The instrument has two means of status indication, the audible beeps and a visual
indicator (LED). These indicators are configured by your Hearing Care Professional.
In the table below you find an overview of the behavior and the possible configurations
of the indicators.
Visual indicator
(LED: Light Emitting Diode)
During startup the LED is always lit.
Instrument
After startup the LED will blink according
is turned on
to the active program number when the
instrument is turned ON.
Instrument The blinking pattern indicates the
program setting:
is operating
P1: One blink followed by a pause and
and program
setting then one blink and a pause, etc.
P2: Two blinks followed by a pause and
then two blinks and a pause, etc.
This feature can be disabled.
audible beeps
The instrument will start up by
playing a jingle indicating that
the battery is working and the
instrument is operating.
No audible beeps.
28
Visual indicator
(LED: Light Emitting Diode)
When changing program the LED will
Program
change blinking pattern according to the
switch
selected program number.
Vc preferred The volume control is programmed to
work under normal conditions at a
level setting
certain level. When this level is reached
by adjusting the volume control the LED
initiates a rapid blinking sequence, of
5 blinks.
This feature can be disabled.
audible beeps
When you change program the
instrument will beep according
to the program selected.
Your volume control is pro-
grammed to work under
normal conditions at a certain
level. When this level is
reached by adjusting the
volume control, this is indi-
cated by two short beeps.
29