Xyplex Terminal Server 720 Manual page 88

Troubleshooting
3. A message similar to the following one is displayed if the Terminal Server 720 has
received a load offer from a load server:
Terminal Server, Type 76, Rev x.xx.x
Ethernet address 08-00-87-xx-xx-xx, port x
Evaluating service offers
If you typed a CTRL-T after "autobauding" your terminal, messages similar to these will
appear when the unit has stopped accepting load offers:
Received load service offers:
Host Address
xx-xx-xx-xx-xx-xx
One to ten load server addresses are displayed (typically, just one). The Terminal
Server 720 selects the load server with the highest merit value.
If you you do not see this message, the load server may not be configured properly. If you
have a VAX/VMS load server, you should make sure that the logical name "MOM$LOAD"
is defined properly. (Refer to the Software Installation Guide supplied with your VMS
software kit.) If you have a UNIX load server, refer to section D.9 for more details on
troubleshooting Internet loading problems.
4. When the Terminal Server 720 chooses a load server, a message similar to this one
appears:
Terminal Server, Type 76, Rev x.xx.x
Ethernet address 08-00-87-xx-xx-xx, port x
Loading over Link L1 from server xx-xx-xx-xx-xx-xx, message 0
Link L1 refers to the Ethernet transceiver cable, 10Base-T network cable or FOIRL cable;
that is, the unit is loading via the LAN. If the message count remains at zero while you type
RETURNs continuously, the load server was configured to load the Terminal Server 720,
but encountered a problem with the load file or directory. Check the file name and
directory at the load server.
D-90
protocol merit
0809 9C000037
filename
XPCSRV20
0021