Advertisement
1. The white plug on the vibration module
plugs into the connector on the HUB from
the main ADAS-100 unit marked vibrator.
2. The module can be mounted 2 ways.
2a. Insert the module into the black cloth
sleeve and attach to the vehicle seat belt.
Attach the belt that DOSE NOT move or
retract. Take caution not to pinch the cable
in the track from the seat.
2b. Cut a small slit in the bottom seat foam
from under the seat. Be careful not to cut
the seat cover be going all the way through.
Insert the module into the foam and secure
module to foam. Run the cable with any
factory harnesses and secure with zip ties.
Take caution not to pinch the cable in the
track from the seat.
The switch on the module will change the
output of the vibration.
1-low
2-medium
3-high
ADAS-1020 Instructions 1-10-18
INSTALLATION INSTRUCTIONS
Page 2 of 2
Advertisement
