Table of Contents
Advertisement
1.3
Electrical safety
+
The equipment requires a 220 - 230V / 50 Hertz mains power supply.
+
The equipment should be connected directly to a grounded plug socket only by means of the
power cable supplied. The use of multi-socket adapters or similar is not recommended. Extension
leads must comply with local electrical safety guidelines. Always fully unwind the power cable.
+
The outlet should be secured with a fuse with a minimum value of „16 amperes, slow".
+
When plugged in, do not leave the equipment unattended at any time. To avoid use by anyone
unfamiliar with the operation instructions, the power cable should be removed when the equip-
ment is not in use.
+
Keep the power cable away from heat, oil and sharp edges. Do not route the power cable under-
neath the equipment or under a carpet or rug, and do not place any objects on top of it.
+
In order to reduce the risk of an electric shock, always unplug the equipment from the mains so-
cket immediately after your workout, before assembly or dismantling, and before maintenance
or cleaning. Do not pull on the cable.
+
Make no modifications to either the power cable or the mains plug.
+
If the power cable or the plug are damaged or defective, contact your authorized contract part-
ner. Do not use the equipment in the meantime.
+
Do not keep electrical devices (e. g., mobile phones) in close proximity to the console or the
control electronics, otherwise display values (e. g., pulse measuring) could be inaccurate.
1.4
Set-up place
+
The equipment should only be used indoors, in a sufficiently heated and dry area (ambient
temperature between 10°C and 35°C). The equipment should not be used outdoors or in rooms
with high humidity (over 70%) like swimming pools. The equipment should only be stored in
surroundings with an ambient temperature between 5°C and 45°C.
+
The training room should be well ventilated during training and not be exposed to any draughts.
+
Choose a location in which to place the equipment such that there is enough free space/
clearance to the front, the rear and to the sides of the equipment (at least 1.50 m). Furthermore,
the equipment should not be set up in main entrances or on escape routes.
+
Always keep the power cable away from hot surfaces and grounds and make sure that the cable
is not stuck somewhere or becomes a „trip hazard".
7
Advertisement
Table of Contents
