RED ROCKET-X INSTALLATION INSTRUCTIONS
INSTALL RED ROCKET-X AND HD-SDI SLOT FILLER
Since each Windows-based computer is different and highly customizable, the instructions in this section are general
and cover the essential steps for installing a RED ROCKET-X and HD-SDI slot filler (optional) in a Windows-based
computer.
Depending on how your system is set up, you may need to rearrange components in your system or perform actions
not described in these instructions in order to successfully install the RED ROCKET-X and HD-SDI slot filler. For more
information about installing components in your system, refer to the computer manufacturer instructions.
WARNING: The computer system you are installing the RED ROCKET-X in works with voltages that can be hazardous
to your health.
1. Ensure that the computer is turned off.
2. Wait 5 to 10 minutes to ensure that the system components cool down.
3. Unplug the power cable and all external cables from the computer.
WARNING: Never work on the system or access its interior while any power cables are plugged in.
4. Touch the metal on the outside of the computer to discharge any static electricity from your body.
NOTE: To avoid generating static electricity while installing the RED ROCKET-X, DO NOT walk around the room
until you have completed the installation and closed the computer.
5. Lay the Windows-based computer on its side.
6. Open the computer panel so that you can access the PCIe slots. For more information, refer to the computer
manufacturer instructions.
Figure: Remove Panel
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 3 3 , R EV - T | 2 1