Table of Contents
Advertisement
RED ROCKET-X INSTALLATION INSTRUCTIONS
10. If you are using the HD-SDI slot filler, follow the instructions below to install and connect the HD-SDI slot filler:
For more information, go to
A. Remove one (1) free slot bracket from the system.
B. Slide the HD-SDI slot filler into the empty slot so that the SDI Out B connector is toward the back.
Figure: Install HD-SDI Slot Filler
CAUTION: Ensure that the HD-SDI slot filler or connectors DO NOT contact other components inside the
chassis.
C. Hand-tighten the screw that attaches the HD-SDI slot filler to the chassis. If it is difficult to hand-tighten the
screw, use a Phillips
D. Connect the SDI Out A cable on the HD-SDI slot filler to the SDI Out A connector on the RED ROCKET-X. The
SDI Out A connector is the right connector when the RED ROCKET-X is installed.
E. Connect the SDI Out B cable on the HD-SDI slot filler to the SDI Out B connector on the RED ROCKET-X. The
SDI Out B connector is the left connector when the RED ROCKET-X is installed.
Figure: Connect HD-SDI Slot Filler to RED ROCKET-X
11. Reinstall the chassis casing.
12. Reconnect all cables to the chassis.
13. To install or upgrade the RED ROCKET- X driver and firmware, go to
page 25.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"Supported HD-SDI Signals" on
®
#1 screwdriver.
page 43.
"Install RED ROCKET- X Software" on
9 5 5 - 0 0 3 3 , R EV - T | 1 9
Advertisement
Table of Contents
