RED ROCKET-X INSTALLATION INSTRUCTIONS
20. Place the PCI bracket under the brace and tighten the two (2) thumbscrews to secure the RED ROCKET-X.
NOTE: The photo below shows the system without the HD-SDI slot filler installed.
Figure: Install PCI Bracket
21. Reinstall any cards that you removed from the system.
22. Reinstall any hard drives that you removed from the system.
23. Slide the PCIe fan toward the RED ROCKET-X until it locks back into place.
Figure: Slide PCIe Fan to Original Position
24. Reinstall the side access panel.
25. Reconnect all cables to the computer system.
26. To install or upgrade the RED ROCKET- X driver and firmware, go to
page 25.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"Install RED ROCKET- X Software" on
9 5 5 - 0 0 3 3 , R EV - T | 1 5