Stain Removal Guide - Haier QFW150 Series Owner's Manual & Installation Instructions

USING THE WASHER

Stain Removal Guide

H
The Stain Removal guide is pre-programmed with the ideal wash and rinse settings to tackle five
common stains. To use this feature, select the desired wash cycle and locate the Stain Removal
guide menu and select the stain you want to remove. Next, press Start.
For some stains, a prewash will be selected automatically. If desired, add detergent or wash additive
to the prewash dispenser. Add Steam cannot be selected along with this feature.
Options
I
B
Prewash
Prewash is an extra wash before the main wash. Use it for heavily soiled clothes or for clothes
with a care label that recommends prewashing before washing. Be sure to add liquid or powder
high efficiency detergent, or the proper wash additive to the prewash dispenser. The PreWash
feature will fill the washer with water (adding the prewash detergent), tumble the clothes, drain
and spin. Then the washer will run the selected wash cycle. NOTE: The PreWash is not selected
automatically and must be selected before starting the cycle.
PreWash
Compartment
Tumble Care
Freshly tumbles your garments periodically for up to 8 hours after the wash cycle is complete to
lessen the setting of wrinkles and creases when you are not able to move clothing to the dryer right
away. At the end of the cycle, the display will scroll "END" and after ten minutes the Tumble Care
will begin. It can be stopped at any time by pressing the Power button. NOTE: The Tumble Care
option cannot be added to the My Cycle feature.
Steam
Steam adds steam into the washer early in the cycle to assist with loosening stains on the Towels/
Sheets, Normal, Whites, Bulky, Active Wear, Power Clean, Sanitize or Allergen cycles.
My Cycle
J
B
My cycle
Set up your favorite combination of settings for each cycle and save them here for one touch recall.
These custom settings can be set while a cycle is in progress.
NOTE: You can store 1 My Cycle combination of settings for each cycle.
To store a My Cycle combination of settings:
1. Select your washing cycle.
2. Change Temp and Level settings to fit your needs.
3. Select any washing options you want.
4. Press and hold the
To recall your stored My Cycle combination:
Select the cycle and press the
To change your stored My Cycle combination:
Repeat steps 1–4.
10
To use:
1. Turn power ON and select a wash cycle. The Steam option is only available on Towels/Sheets,
Normal, Whites, Bulky, Active Wear, Power Clean, Sanitize or Allergen cycles.
2. Select the Add Steam button to activate steam.
3. Press the Start/Pause button.
for 3 seconds to store your selection. A beep will sound and the button
will light up.
before washing a load.
49-3000191 Rev. 1