Personal Safety - Fieldmann FZN 2000-E Manual

EN 8 Safety instructions
Water entering a machine will increase the risk of electric shock.
Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the electric tool.
Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
When operating an electric tool outdoors, use an extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
If operating an electric tool in a damp location is unavoidable, use a residual current device
(RCD) protected supply.
Use of an RCD reduces the risk of electric shock.

Personal Safety

Stay alert, watch what you are doing and use common sense when operating an electric
tool. Do not use an electric tool while you are tired or under the influence of drugs, alcohol or
medication.
A moment of inattention while operating power tools may result in serious personal injury.
Use adequate personal protective equipment. • Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will reduce personal injuries.
Prevent unintentional starting of the tool. Ensure the switch is in the off-position before
connecting to power source and /or battery pack, picking up or carrying the tool.
Carrying electric tools with your finger on the switch or energising electric tools that have the
switch on invites accidents.
Remove any adjusting key or wrench before turning the electric tool on.
A wrench or a key left attached to a rotating part of the power tools may result in personal
injury.
Do not overreach. Keep proper footing and balance at all times.
This enables better control of the electric tool in unexpected situations.
Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves
away from moving parts.
Loose clothes, jewellery or long hair can be caught in moving parts.
If devices are provided for the connection of dust extraction and collection facilities, ensure
these are connected and properly used.
Use of dust collection can reduce dust-related hazards.
Electric Tool Use and Care
Do not force the electric tool. Use the correct electric tool for your application.
The correct electric tool will do the job better and safer at the rate for which it was designed.
Do not use the electric tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
FZN 2000-E