Ice Maker Door - Jenn-Air JIM1550ARB Service Manual

Wood Screws
1. #8 pan head wood screws are recommended to
properly secure the custom wood panel to the ice
maker door.
2. A total of 10 screws are needed.
3. Use only pan head screws.
4. Be sure the screw length is NOT longer than the
wood thickness at the screw locations.
5. Use the following pilot hole drill sizes.
Type of Pilot Hole Drill Size for
Wood #8 Pan Head Wood Screws
Hardwood
Softwood
Prepare the Wood Panel
14 3
⁄
(37.47 cm)
10 Pilot Hole
Locations
25 5 "
⁄
8
(65.07 cm)
Inside of Door
3 " (.23 cm)
⁄
32
5 " (.20 cm)
⁄
64
"
4
Custom panel
thickness:
5 " to
⁄
8
(1.57-1.91 cm)
Attach the Wood Panel to the

Ice Maker Door

1. Place the custom wood panel on a non-abrasive
surface, protected by towels or rugs, to avoid
accidental damage to the door finish.
2. Place the ice maker door flush with the inside
surface of the custom wood panel. Clamp the
wood panel to the door, if necessary.
3. Mark the hole locations with a pencil.
4. Drill the pilot holes into the custom panel.
5. Insert the wood screws through the back of the
door and into the pilot holes in the custom wood
panel and tighten.
6. Reinstall the door seal by pressing it into the door
channel. Making certain the corners are fully
inserted.
7. Install the door back on to the ice maker using the
supplied plastic washers (as shown below).
8. Realigning the door may be necessary (see page 8).
3 "
⁄
4
•
Door can become disengaged if washers are not
installed.
•
Door may not swing properly if all nylon components
are not installed as shown.
Top Hinge Corner
Bottom Hinge
Corner
Cabinet Hinge
CAUTION
Cabinet Hinge
Shoulder Bushing
Door Hinge
Door Hinge
Shoulder Bushing
Washer
(Optional)
Washer
9