Reversing The Door - Jenn-Air JIM1550ARB Service Manual

Installation

Reversing the Door

• Disconnect power to the ice maker before
reversing the door.
1. Turn OFF the ice maker
and disconnect the
power. Remove top
hinge pin with a
1 " Allen wrench.
⁄
8
Remove door by pulling
it out and upward off
bottom hinge pin. Set
aside, face down on
surface that will not
scratch the finish.
Remove the small plastic washer from bottom
hinge pin.
2. Remove the six small
plastic hole plugs from the
left hand hinge holes
using the putty knife.
Using a " socket,
5
⁄
16
wrench or nut-driver,
remove bottom hinge.
Reinstall hinge, moving it
to the top left hand side.
Using a 1 " Allen wrench, remove the hinge pin
⁄
8
from the top left hinge, and install in top right
hinge. Now move top right hinge to left bottom.
Flip the door over and reinstall the small plastic
washer on the bottom hinge pin. Install hole plugs
in right side.
3. Reinstall the door by
locating it over the
bottom hinge pin and
pushing down and in.
Reinstall the top
hinge pin. Check the
door for proper
alignment. The top
and sides of the door
should run parallel to
the top and side edges
of the cabinet. Some
misalignment is acceptable, but the door gasket
must seal fully against the cabinet.
8
, cont.
WARNING
Top of
Unit
Out
Hinge
Bracket
Up
Hole Plugs
Move
Hinge
Pin
Hinge
Bracket
In
Down
Realigning the door may be necessary. Using a
Allen wrench, loosen the two screws on the top
and bottom adjustable door hinge bracket. Adjust
the door to proper alignment. Make sure door
gasket seals fully against the cabinet front.
Retighten screws after making adjustments.
4. Plug the ice maker in and turn the control
back to the ON setting.
Hinge
Pin
Installing the Custom Door
Panel
(select models)
• Disconnect power to ice maker before installing
the custom door panel.
The dimensions for a decorative custom door panel are:
14 3 " Width
⁄
4
25 5 " Height
⁄
8
3 " Thickness (maximum)
⁄
4
1. Turn off the ice maker and
disconnect the power.
2. Remove 1
screw (A) from the
top hinge. Remove
the door off of the
lower hinge, noting
washer location.
3. Remove the door
seal (B) to expose the screw
holes.
Custom Handle
1. A custom handle (not supplied) must be installed.
Top of
Unit
2. Drill pilot holes through the custom panel to match
the handle. Countersink the holes on the back of
the panel.
3. Attach the custom handle to the front door panel
assembly.
NOTE: The custom handle screws should be installed
through custom panel and into the custom handle. The
screw heads should be countersunk so the inside panel
surface can be installed flush with the ice maker door.
WARNING
A
" set
⁄
8
B
1 "
⁄
8