Jenn-Air JIM1550ARB Service Manual page 30

Installation
Drainage
Your ice maker uses a gravity drain that requires
tubing from the back of the ice maker to a plumbed
connection to a sanitary sewer (see illustration to the
below). Remove the access panel to plumb in drain
connection. Gravity drain location for built-in units can
be within the shaded area shown. An optional drain
pump can be purchased for your ice maker if a gravity
drain is not accessible.
NOTE: Avoid kinks and check for proper water
drainage after ice maker installation.
OBSERVE AND FOLLOW ALL LOCAL CODES
WHEN INSTALLING ICE MAKER.
Front
Top
of Unit
of Unit
23
Gravity Drain Location
Locate standpipe
3"
8"
• Failure to use adequate drainage system will result
in surrounding water damage and/or poor ice
production.
• Water damage due to the use of an inadequate
drainage system may cause mold/mildew growth.
6
, cont.
1 1 "
⁄
4
6 3 "
⁄
4
14 3
2 3 "
⁄
8
4 1 "
⁄
16
21 1 " Baseplate
⁄
8
Opening for
1 "
⁄
2
Gravity Drain
as shown.
15"
WARNING
Gravity Drain
5 " I.D.
⁄
8
Drain from
Ice Maker
"
⁄
4
Drain Pump (sold separately)
Tubing
Clamps
To purchase an optional drain pump, contact the dealer
where you purchased the ice maker or Jenn-Air
Customer Assistance: 1-800-JENNAIR (1-800-536-
6247). Drain pump model number: JIMPUMPAXX.
NOTE: Detailed installation instructions are provided
with the drain pump kit.
5 " I.D. Drain
⁄
8
Tubing and
Hose Clamp
1
Drain
Trap
Ice Maker
Power Cord
Vent
Discharge tube goes
Tube
through this opening
in the access panel.
Drain from Ice Maker
Drain Pump
Drain Pump
Power Cord
Vent tube goes through this
opening in the access panel.
1 " Drain Pipe
⁄
2
Access
Panel
Access
Panel