Fastening The Workpiece - Westfalia 84 38 60 Original Instruction Manual

Fastening the Workpiece

The metal cutting saw is equipped with a quick-clamp vice.
j k
1. To fasten the workpieces firmly on the base plate, first lift up the thread
lock (l) from the thread rod.
2. For a straight cut move the vice backstop (9) until the 0°-position on the
scale lines up with the marking on the base plate. If necessary, slightly
loosen the hex screws 1 and 2 (i and j) in order to be able to move the
mitre square scale. Afterwards re-tighten the screws with the Allex key.
When performing a mitre cut, adjust the vice backstop (9) up to the de-
sired angle and make sure the angle lines up with the marking on the base
plate. Mitre cuts up to an angle
of 45° are possible. If you have
loosened the hex screws 1 and
2 (i and j), re-tighten the
screws hand tight.
3. Finally move the thread rod
forth or back up to the work-
piece in order to tighten it
firmly on the base plate.
Operation
h
i
20
h
i
j
k
l
l
Hex Key
Hex Screw 1
Hex Screw 2
Scale
Thread Lock