BEFORE USING THE APPLIANCE FOR THE FIRST TIME
Make sure that the plastic packaging protecting the filters has been removed before using the appliance.
Also make sure that:
• The voltage of your electrical installation corresponds to the one indicated on the appliance.
• Your appliance can be used with a power plug without an earth connection. It is a class II ap-
pliance (double electrical insulation),
• The appliance is positioned in the house as described above,
• The air inlet and outlet grids are completely unobstructed,
• Ensure the 4 filters and front panel have been correctly installed (see section titled filter as-
sembly/dismantling paragraph).
This appliance is fitted with a device that automatically prevents it from operating if the front
door is not correctly assembled.
Inserting and replacing the filters
This appliance is equipped with 4 types of filters:
Pre-filter
NB: For optimum performance of the appliance, only use filters provided by TEFAL.
To replace the filters, follow the instructions in the section « Disassembling/Reassembling filters ».
Please note: certain filters may emit a temporary slight odour, due to the transport and storage
conditions.
SWITCHING THE APPLIANCE ON
Setting the pollution sensors
The appliance is preset to medium sensitivity.
If the air quality indicator remains:
– poor after 2 hours in operation although the air seems to be purified
– excellent for more than 1 hour although the air seems to be polluted
you can adjust the sensor sensitivity as follows:
1. When the air purifier is off, hold down the mode setting button for 3 seconds:
2. Set the sensitivity by briefly pressing the mode setting button:
+ Blue
Low sensitivity
• Select high sensitivity if the air purifier indicates excellent air quality for more than 1 hour although the air
seems to be polluted.
Active carbon
filter
+ Purple
Medium sensitivity
True HEPA
Allergy+ filter
High sensitivity
NanoCaptur
filter
+ Red
7
EN