Table of Contents
Advertisement
CAUTION:
If the System slide rails are installed above EIA location 29U, the [ServerLIFT
tool (or other qualified lift tool) must be used as a safety precaution for
servicing. Position the lift tool platform slightly below the bottom of the System
drawer to account for the slight downward flex when the drawer is extended out
fully on its slides. Then gently raise the lift tool platform to stably contact the
bottom of the drawer, minding not to over force it as it could put upward stress
to the slide rails. A service-qualified ladder may have to be used to reach or
properly work around the System at such heights. While using a ladder, do not
lean on or against the system drawer or lift tool during service, and follow safe
practices. (C051)
DANGER
About this task
Important: The 2076-92F expansion enclosure is heavy. Before you install the
expansion enclosure in the rack for the first time or replace it in the rack to
complete a service task, perform the following tasks:
54
Storwize V7000 Gen2 and Gen2+: Quick Installation Guide
v Do not operate while under the influence of drugs or alcohol.
v Do not support ladder against LIFT TOOL.
v Tipping hazard. Do not push or lean against load with raised platform.
v Do not use as a personnel lifting platform or step. No riders.
v Do not stand on any part of lift. Not a step.
v Do not climb on mast.
v Do not operate a damaged or malfunctioning LIFT TOOL machine.
v Crush and pinch point hazard below platform. Only lower load in areas clear of
personnel and obstructions. Keep hands and feet clear during operation.
v No Forks. Never lift or move bare LIFT TOOL MACHINE with pallet truck, jack or
fork lift.
v Mast extends higher than platform. Be aware of ceiling height, cable trays, sprinklers,
lights, and other overhead objects.
v Do not leave LIFT TOOL machine unattended with an elevated load.
v Watch and keep hands, fingers, and clothing clear when equipment is in motion.
v Turn Winch with hand power only. If winch handle cannot be cranked easily with one
hand, it is probably over-loaded. Do not continue to turn winch past top or bottom of
platform travel. Excessive unwinding will detach handle and damage cable. Always
hold handle when lowering, unwinding. Always assure self that winch is holding
load before releasing winch handle.
v A winch accident could cause serious injury. Not for moving humans. Make certain
clicking sound is heard as the equipment is being raised. Be sure winch is locked in
position before releasing handle. Read instruction page before operating this winch.
Never allow winch to unwind freely. Freewheeling will cause uneven cable wrapping
around winch drum, damage cable, and may cause serious injury. (C048, part 2 of 2)
DANGER: Serious injury or death can occur if loaded lift tool falls over or if
a heavy load falls off the lift tool. Always completely lower the lift tool load
plate and properly secure the load on the lift tool before moving or using the
lift tool to lift or move an object. (D010)
®
]
Advertisement
Table of Contents
