Connection To The Mains Network; Cleaning Preserving Agent When Starting-Up Of Operation Initially; Taking The Unit Into Operation With Coating Material; Digital Electronic Spray Control (Esc) System - WAGNER ProSpray 30 Operating Manual

Starting operation

4.4 Connection to the mains network

The unit must be connected to an
appropriately-grounded safety outlet.
Attention
Before connecting the unit to the mains supply, ensure that the
line voltage matches that specified on the unit's rating plate.
4.5 Cleaning preserving agent when
starting-up of operation initially
1. Immerse the suction tube (Fig. 8, Item 1) and return hose
(2) into a container with a suitable cleaning agent.
2. Turn the pressure control knob (3) to the yellow zone to
minimum pressure.
3. Open the relief valve (4), valve position PRIME
(k circulation).
4. Switch the unit (5) ON.
5. Wait until the cleaning agent exudes from the return hose.
6. Close the relief valve, valve position SPRAY
(p spray).
7. Pull the trigger of the spray gun.
8. Spray the cleaning agent from the unit into an open
collecting container.
5
3
1
2
32
GB
4.6. Taking the unit into operation with
coating material
1. Immerse the suction tube (Fig. 8, Item 1) and return hose
(2) into a container with a suitable cleaning agent.
2. Turn the pressure control knob (3) to the yellow zone to
minimum pressure.
3. Open the relief valve (4), valve position PRIME
(k circulation).
4. Switch the unit (5) ON.
5. Wait until the coating material exudes from the return
hose.
6. Close the relief valve, valve position SPRAY
(p spray).
7. Trigger the spray gun several times and spray into a
collecting container until the coating material exits the
spray gun without interruption.
8. Increase the pressure by slowly turning up the pressure
control knob.
Check the spray pattern and increase the pressure until
the atomization is acorrect.
Always turn the pressure control knob to the lowest setting
with good atomization.
9. The unit is ready to spray.
4.7. Digital ESC System
The Digital ESC System increases the functionality of the
sprayer. It is installed directly below the pressure control knob
on the control panel. It consists of a display and four function
keys. The display shows various menu screens that allow the
user to customize and monitor sprayer operation using the
function keys.
Display
Function
Keys
The pressure control knob overrides the Digi-
i
4
tal ESC System settings. Anytime the pres-
sure control knob is turned, the sprayer pres-
sure will change accordingly.
Function Keys
The function keys are numbered 1–4. Each key is labeled with
an additional function as well.
#1/Menu Key
Pressing the #1 key scrolls through the available menu screens
or performs a function described on the active menu screen.
#2/+ Key
Pressing the #2 key performs a function described on the
active menu screen or increases a value.
#3/- Key
Pressing the #3 key performs a function described on the
active menu screen or decrease a value.
#4/Select Key
Pressing the #4 key selects the active menu screen or
performs a function described on the active menu screen.
Menu Screens
Several menu screens are available for the user to customize
and monitor sprayer operation. They include Main Screen,
User Pre-Sets, Volume Pumped, Job Volume, Unit Serial #,
TImers, Job Timers, Service Time, Pressure, Security Code,
Prime, and Pulse Clean.
SET MPa 23.0
ACTUAL MPa 22.5
+ –
MENU SELECT
1 2 3
ProSpray 30 • 34
4