Table of Contents
Advertisement
3.4 Network Configuration
Use this menu to configure the network to
connect the device.
There are three connection types:
Static Address (Leased Line User)
DHCP Client IP Address (Cable Modem User)
PPPoE (ADSL Dial-up User)
Connect the Ethernet cable to your control gateway and to a network port on your
Step 1.
internet router.
Connect your computer to the same internet router with control gateway.
Step 2.
Run Planet Smart Discovery Utility to find the IP of control gateway.
Step 3.
Start the web browser on the computer and type the IP address you search from Planet
Step 4.
Smart Discovery Utility of the control gateway.
Even though the control gateway cannot be found, you can still connect your
computer straight to the HAC-1000. And set the same IP segment with control
gateway in TCP/IP of your computer. Then use default IP of control gateway:
http://192.168.0.253
"
3.4.1 Static Address
On this page, you can configure the network interfaces.
Parameters
IPv4 address
IPv4 netmask
IPv4 gateway
IPv4 broadcast
Use custom DNS
servers
"
to access the web UI of control gateway.
Description
This address is a unique number that identifies a computer or device
on the WAN or LAN. These numbers are usually shown in groups
separated by periods, for example. 192.168.0.200.
Subnets allow network traffic between hosts to be separated based
on the network's configuration. In IP networking, traffic takes the form
of packets. IP subnets advance network security and performance to
some level by organizing hosts into logical groups. Subnet masks
contain four bytes and usually appear in the same "dotted decimal"
data. For example, a very common subnet mask in its binary
demonstration 11111111 11111111 11111111 00000000 will usually be
shown in the corresponding, more readable form as 255.255.255.0.
A gateway is a piece of software or hardware that passes information
between networks. You'll see this term most often when you either
log in to an Internet site or when you're transient email between
different servers.
Broadcast address, if leave blank, the system will automatically
calculate.
When you send email or position a browser to an Internet domain
such as xxxxx.com, the domain name system translates the names
into IP addresses. The term refers to two things: the conventions for
naming hosts and the way the names are control across the Internet.
17
-
-
Z-Wave Home Automation Control Gateway
HAC-1000
Advertisement
Table of Contents
