Assembly; Important Information; Handles - Webb WER460SP Original Instructions Manual

INSTRUCTION MANUAL

ASSEMBLY

Remove the machine and contents from the carton. Be sure the carton is empty before discarding.
If you require any assistance with regards to the contents of the machine, contact us:
Tel: 01793 333212 - Mon – Fri 8.00am – 5.30pm (excl. Bank Holidays)
Email: customerservice@webbgardenpower.co.uk

IMPORTANT INFORMATION

NOTE: This product is a 4-stroke engine powered machine.
The engine MUST be filled with recommended 4-stroke SAE30 or 10W/30 air cooled lawnmower engine oil
BEFORE starting. Fresh unleaded petrol must be used in this unit. DO NOT use Ethanol based fuels. DO NOT
mix oil with fuel.
Stop the engine and unplug the spark plug before any repairs or maintenance operations.
DO NOT attempt to start this machine without it first being FULLY assembled.
DO NOT attempt to start this mower without first adding 4-stroke SAE30 or 10W/30 air cooled lawnmower

HANDLES

1. To attach the lower handle, first remove the two lower handlebar knobs and washers. Please note that the
bolts have a two-phase thread, to stop the knobs was coming off the bolt accidently and being damaged.
2. Place the lower handle in position by aligning the lower handle with the outer side of the metal mounting
plates located at the back of the mower deck.
3. Once in position, insert the bolt on each side through the mounting plate and then through the lower
handle.
4. Once the bolts are loosely in position, attach the washer and lower handlebar locking knobs onto the
outer side of the lower handles and secure until tight.
10
WARNING
engine oil to the engine.